Taylor,
Let me recombine the questions ;-)

> For a 76 oz CS maker,
>
> << Will a set up of 3 9V batteries be up to the
>  job?   If so, how many runs do you think?>>
>
<< Should the silver wires I buy be long
 enough to almost touch bottom, or will 6 inch wires do? >>

<< What was it again that I should be
 careful NOT to buy when I buy
 alligator clips?  Lead solder? >>

<< How long will I have to run the cs maker to
 get 76 oz of distilled water to 10 ppm? >>

I can answer two.

It doesn't matter what type of alligator clips you buy, as long as
they make good contact with the silver electrodes and make no contact
with the water.

Oh, make that one.

Your other questions lie in the 'try it and see' basket.

The longer the electrodes the more current you will draw and the
quicker the reaction will be.
How long it will take depends on your 'recipe'. Voltage, current limit
(or not), electrode length, distance apart. 76 oz = 2.25L, if the
electrodes are 6" long, 2" apart, you run with 27V and have no current
limit, then I would guess 10ppm in about 3 hours.
How long the batteries would last, I don't know. Why not buy a small
power supply, say 24V, this would allow for repeatable results and
enable proper evaluation of test runs. Do two or three runs of
different time lengths and send samples to Robert Berger for testing.

Good Luck - Ivan


--
The silver-list is a moderated forum for discussion of colloidal silver.

To join or quit silver-list or silver-digest send an e-mail message to: 
[email protected]  -or-  [email protected]
with the word subscribe or unsubscribe in the SUBJECT line.

To post, address your message to: [email protected]

List maintainer: Mike Devour <[email protected]>