Hi guys. I have a Silver Puppy, but perhaps this question applies to
other generators as well. If I brew a batch of CS and the electrodes
don't 'seem' to have any silver residue on them when it is finished, can
I just skip wiping them down with a paper towel and run another batch
without any adverse effect on that subsequent batch?
.
I should say that some of the black silver residue is there on one
electrode, but there is hardly any white silver residue (which I believe
is silver oxide?) at all on the other. Sometimes I make a batch and
there is so much of that white silver residue, but this time, and at
other times for reasons I don't understand, there is hardly any, and
because of that, I didn't wipe the electrodes down. Is that okay? The
water I'm using has been consistently good, by the way. Not sure if
that makes a difference regarding my question.
Thanks. Jodi
--
The Silver List is a moderated forum for discussing Colloidal Silver.
Instructions for unsubscribing are posted at: http://silverlist.org
To post, address your message to: [email protected]
Address Off-Topic messages to: [email protected]
The Silver List and Off Topic List archives are currently down...
List maintainer: Mike Devour <[email protected]>