>I have only recently started making colloidal silver and sometines the
water turns a >pale yellow as it cools and other times it turns a deep
amber. Why does this happen >and  what does the color mean? if I do not boil
the distilled water first it remains clear >even after it has cooled and I
don't understand this. Anyone know? Thanks much.

One of the more cogent explanations for the often touted yellow color was
offered by Peter A. Lindemann in his article about colloidal silver
entitled: Colloidal Silver, A Closer Look. To quote Peter's article
directly:

There has been a fair amount of controversy in the public literature
concerning the appearance of the "yellow" color. A lot of well meaning
people have told me that "yellow is bad", "silver isn't yellow", "yellow is
sulfur contamination", "yellow is iron contamination", and lots of other
things. I finally found what I believe to be the answer to this question in
a book titled Practical Colloid Chemistry, published in London in 1926. In
the section on the "Colours of Colloidal Metals", sub-section on the
"Polychromism of silver solutions" on page 69, I found the following
statements: "The continuous change in colour from yellow to blue corresponds
to a change in the absorption maximum of the shorter to longer wave-lengths
with a decreasing degree of dispersion. This is a general phenomenon in
colloid chemistry illustrating the relation between colour and degree of
dispersion." This section goes on to describe the colors that show up in a
wide variety of colloidal metal solutions. Interestingly, they ALL have
ayellow phase.

For true "electro-colloidal" silver, the particle size range thatcan appear
yellow is .01 to .001microns (10 to 100 angstroms) because that is the size
of silver particle that best absorbs theindigo light, leaving only its
inverse color, yellow, to beobserved. The final transparent-yellow
appearance only shows up after the particles have become evenly dispersed.


Clear Color

A few individuals who sell colloidal silver or colloidal silvergenerators
claim that a clear solution is more desireable .According to Dr Bob Beck,
silver atoms sinter off the wire in equal particle size (approximately .001
microns) when using a DC generator of approximately 30 volts. Therefore,
with a DC generator, distilled water will usually begin to turn a pale
yellow color when the concentration approaches 7-10 ppm. Higher
concentrations reveal a deeper yellow color, while lower concentrations
(usually 1-5 ppm) display more of a clear color.

Yours in health,
James Allison



--
The silver-list is a moderated forum for discussion of colloidal silver.

To join or quit silver-list or silver-digest send an e-mail message to: 
[email protected]  -or-  [email protected]
with the word subscribe or unsubscribe in the SUBJECT line.

To post, address your message to: [email protected]

List maintainer: Mike Devour <[email protected]>