As ionic silver evaporates, the ions oxidize into brown to black silver oxide.
They can't survive as ions without the water.
It wasn't a photo reaction, it was evaporation.

Ode


At 03:28 PM 5/12/2010 -0800, you wrote:
I have a small abrasion on my forearm.  I decided to dip a cotton ball in
some of my EIS concentrate and tape it to my arm for a couple of hours.  I
was out in the sun for part of that time.  When I came back in, I noticed
that the cotton ball had turned brown.

I then took a fresh cotton ball, soaked it with the EIS concentrate and set
it outside in the sun.  It turned brown in a little over 15 minutes.

I then took another fresh cotton ball and soaked it with my EIS and set it
outside in the sun.  To my surprise, it also turned brown.

When I make EIS, I start with distilled water that has a conductivity of
less than 0.5 uSeimens, and the EIS comes in at about 14 uSeimens of
conductivity.  To make the EIS concentrate I put EIS in a stainless pan and
warm it up.  When the volume is reduced to about half, I stop.  In this case
the conductivity came in at 34 uSeimens.  The solution remains clear and
there is no percipitate of silver in the bottom of the bottle that it is
stored in.  This concentrate is for external use only and I have done this
several times without incident.

Why is my EIS and my EIS concentrate photo sensitive?

Is this normal?

The brown is like a dark sepia tone.

Tom



--
The Silver List is a moderated forum for discussing Colloidal Silver.
  Rules and Instructions: http://www.silverlist.org

Unsubscribe:
  <mailto:[email protected]?subject=unsubscribe>
Archives:
  http://www.mail-archive.com/[email protected]/maillist.html

Off-Topic discussions: <mailto:[email protected]>
List Owner: Mike Devour <mailto:[email protected]>