This is on our site.
Trem
1. Remove the carbon discharge filter. It makes the water conductive.
2. Fill the boiling chamber no more than 3/4 full.
3. Distill only 1/2 gallon into the receiver.
4. Discard the remainder in the boiling chamber.
5. Repeat steps 2,3 and 4. You now have one gallon in the receiver.
6. Put 3/4 gallon of this water in the boiling chamber.
7. Distill only 1/2 gallon into the receiver.
You now have what is called double distilled water.
Allow to cool and try to use it. It should measure less than 1 microsiemen
using a PWT meter..
----- Original Message -----
From: "Beth" <csilverl...@yahoo.ca>
To: "silver-list" <silver-list@eskimo.com>
Sent: Tuesday, November 02, 2010 9:05 PM
Subject: CS>distiller/ppm/hanna meter
Okay so I did my first batch of water in the distiller.
No filter.
I calaborated my hanna pwt to 84.0 as per solution requirements.
Then tested the first batch of distilled water.
It reads 2.8
So is that because I have no filter? or maybe because it is the
first time I used the unit. I dont know.
I will do another batch tomorrow and see what it comes out to.
It should be 0 to begin with right?
Beth
--
The Silver List is a moderated forum for discussing Colloidal Silver.
Rules and Instructions: http://www.silverlist.org
Unsubscribe:
<mailto:silver-list-requ...@eskimo.com?subject=unsubscribe>
Archives:
http://www.mail-archive.com/silver-list@eskimo.com/maillist.html
Off-Topic discussions: <mailto:silver-off-topic-l...@eskimo.com>
List Owner: Mike Devour <mailto:mdev...@eskimo.com>
--------------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 9.0.864 / Virus Database: 271.1.1/3233 - Release Date: 11/02/10
00:34:00