Kent, part 3, end. :-)
--
oozing on the muggy shore of the gulf coast
[email protected]
--- Begin Message ---
Ivan Anderson wrote:
>
> -----Original Message-----
> From: Tai-Pan <[email protected]>
> To: [email protected] <[email protected]>
> Date: Saturday, 24 April 1999 09:01
> Subject: CS>555 Timers, I limiters,
>
> Excellent post Bob,
>
> I use a LM-317, in this very arrangement, in my small generators.
> Found it on the web as a cheap and easy NiCad battery charger.
> I found I needed a 10K ohm pot (I use a trimmer) in my application,
> adjusted to supply 0.5mA under full load.
> >
> > A very easy to make adjustable current limiter can be made with only
> >two parts. An LM-317 three terminal regulator and a 250 ohm
> >potentiometer will do it. These are availible at any electronics
> place
> >at low cost, typically about $2.50 for the LM-317 and about $2.00 for
> >the petentiometer.
> > The three terminals are Vin, Vout, and Adj. The Vin terminal
> connects
> >to the power source, the Vout terminal goes to one end of the
> >potentiometer,the Adj terminal goes to the other end of the
> >potentiometer. (a potentiometer is a resistance element with a wiper
> >that moves over the resistence element, it has three terminals).
> > The end of the potentiometer that has the Adj wire attached to it
> goes
> >to the silver electrodes (the load). The center potentiometer
> terminal
> >(the wiper terminal) is connected to the Vout terminal. This mades
> the
> >potentiometer into the same thing as a rheostat ( a two connection
> >variable resister). To use it, place an milliamp meter in the cicuit
> and
> >adjust the *pot*(slang for potentiometer) for the current you want,
> and
> >thats where the current will stay. Of course there has to be current
> >flowing to start with, so wait until you have a good current flow
> before
> >you set it for what you want. The LM-117 can be used in place of the
> >LM-317. This is a little known use of the three terminal regulator.
Hi Ivan and List,
Sorry, I left out the equation for the resistance value.
It is "Iout =1.2/R1", the output current is equal to 1.2 divided by the
effective resistance of the rheostat (potentiometer).
For your 0.5ma the resistance would be 2400 ohms for the effective
resistance of the rheostat. Thats 1.2/.0005 = 2400 ohms, or 1.2/0.5ma.
Of course most CS making will be using much higher currents than 0.5ma.
You adjusted the 10K pot (trimmer) to 2400 ohms.
Bless you Bob Lee
--
oozing on the muggy shore of the gulf coast
[email protected]
--
The silver-list is a moderated forum for discussion of colloidal silver.
To join or quit silver-list or silver-digest send an e-mail message to:
[email protected] -or- [email protected]
with the word subscribe or unsubscribe in the SUBJECT line.
To post, address your message to: [email protected]
List maintainer: Mike Devour <[email protected]>
--- End Message ---