And no discussion of CS bottling would be complete if we didn't 
mention that some folks have stored it in clear bottles in ambient 
room light with no difficulties. Do an archive search on Bob Berger's 
posts if you have any doubt. <grin>

I usually keep a couple of trigger sprayer bottles of CS in the
kitchen and bathroom. Fortunately the plastic these particular
bottles are made of does not cause fallout even after prolonged 
storage. They are the kind used in janitorial work and are labeled 
as being made of HDPE (high density polyethylene).

I keep 'em around for at least a week or two before the stuff gets 
used up, and there has been no noticeable change in color, or any  
fallout on the bottom of the bottles.

My CS is made with a 70 VDC supply, several kilohm resistor in 
series to limit current, 12 gauge wire electrodes, 1.5" spacing, 3.5" 
wetted length, room temp, distilled water only. I wipe the electrodes 
and stir "occasionally" and run until I read about 10 ppm on a TDS 
meter calibrated for sodium chloride. *Actual* ppm is not known.

My house is *not* a brightly lit place, and I do consciously avoid
putting the CS in direct sun, but other than that, light exposure
seems to be less than critical for a well made, "several" ppm, pale
golden or colorless brew.

I wonder if the dark bottle idea was more important to the less 
stable, larger particle stuff that we used to make with salt?

Be well,

Mike D.
[Mike Devour, Citizen, Patriot, Libertarian]
[[email protected]                       ]
[Speaking only for myself...              ]


--
The silver-list is a moderated forum for discussion of colloidal silver.

To join or quit silver-list or silver-digest send an e-mail message to: 
[email protected]  -or-  [email protected]
with the word subscribe or unsubscribe in the SUBJECT line.

To post, address your message to: [email protected]

List maintainer: Mike Devour <[email protected]>