Katarina Wittich wrote:

> Hey everyone -- I just made a batch of cs with my usual setup and some
> distilled water which made clear cs with a strong tyndall in about 1/2 hr a
> few weeks ago. I immediately capped the bottle of water after using it and
> it has been sitting untouched for three weeks. The new batch of cs that I
> made following the same procedure (no salt, room temp, wipe electrodes and
> stir every 15 min) is a grey tinged milky cloudy solution that is scary to
> look at. It started to fill the glass with milky solution within minutes.
>  What could cause this?
> How does water go bad in a few weeks?

Most likely absorbing gases from the air, primarily carbon dioxide making
carbonic acid.

> Does that mean that the water I used before was already probably
> contaminated and I was unwittingly making silver compounds?

Probably not if the previous batch was ok.

Marshall


--
The silver-list is a moderated forum for discussion of colloidal silver.

To join or quit silver-list or silver-digest send an e-mail message to: 
[email protected]  -or-  [email protected]
with the word subscribe or unsubscribe in the SUBJECT line.

To post, address your message to: [email protected]
Silver-list archive: http://escribe.com/health/thesilverlist/index.html
List maintainer: Mike Devour <[email protected]>