Katarina wrote:
> Hi Mike, it was me. I am baffled by this meter stuff, so please
> bear with me.

No problem. You're probably the only one of a dozen lurkers who is 
brave enough to ask! <grin> ( Hi out there, lurkers!!! <waves> )

I'm assuming all you want to do is make sure your CS is about the 
same each time you're done with a batch, and that you can re-test it 
from time to time to detect when an old batch has gone bad for any 
reason.

> First I use the PWT to make sure the water is good. I assume I do
> this by sticking some sort of probe in the water. Do I want to avoid
> doing it in the water that is going to become the cs? will it
> contaminate it?

The PWT is like a better version of the TDS-1 that a lot of us 
already have, I believe. Basically, you just stick the end of the 
meter into the water for a few seconds and read out the conductivity, 
in microSiemens, on the small display. The probes are stainless steel 
and, since there is no applied voltage of any significance in the 
meter circuit, nothing is going to come off of them to contaminate 
your water.

> Then - if I make a batch the way I normally do - how do I use the
> conductivity meter to read it at the end. Do I just stick two
> electrodes that come with the meter into my cs? Will they
> contaminate it as Marshall warns? Do electrodes come with the
> meter?? Or is it clip leads? Help!! I'll have better questions once
> I buy the meter - I'm sure.

You'll stick the end of the meter in the CS just the same, and read a 
new conductivity (much greater) that will become a baseline for 
future batches.

On future batches, occasionally pull the electrodes from the water 
and stir the CS. Then measure with the PWT. When it gets to your 
target value (approximately) you're done.

It is that simple.

Now, this will not tell you directly what ppm you have, which I'm 
sure you understand, but if you send a few samples off for analysis, 
you'll find that conductivity will relate pretty well to ppm if you 
keep your procedures pretty constant.

Be well, ma'am!

Mike D.

[Mike Devour, Citizen, Patriot, Libertarian]
[[email protected]                       ]
[Speaking only for myself...              ]


--
The silver-list is a moderated forum for discussion of colloidal silver.

To join or quit silver-list or silver-digest send an e-mail message to: 
[email protected]  -or-  [email protected]
with the word subscribe or unsubscribe in the SUBJECT line.

To post, address your message to: [email protected]
Silver-list archive: http://escribe.com/health/thesilverlist/index.html
List maintainer: Mike Devour <[email protected]>