Hi Jeff,
that's very helpful. I think you are right -- I don't plug into the pulser
for silver generation -- but into the other output. So then it would work
well for the multimeter -- if I can figure out how to attatch it.
Hope dinner was not too crispy!
Take care,
Katarina

> Hi  Katarina,
>
> The only concern I have in trying to meter the current of the pulser, is in
that
> I'm not sure what the output looks like. If I understand correctly, the pulser
> changes polarity several (4?) times per second. (I'm looking at a schematic
> from Bob
> Beck's site)  This would be equivalent to using a simple setup and swapping
> the leads to the electrodes 4 times per second.
>
> A DC ammeter connected in line would then see the current change direction at
> that rate. If the rate of change were slower, the meter would read a steady
state
> positive reading, and then an equal but negative steady state reading...and so
on.
> This is basically a low frequency AC square wave. With the meter set to DC,
> it might
> just flash a bunch of numbers at you, as it wouldn't react quickly enough
> to display
> the current before it changed direction.
>
> If set to AC, the problem may be similiar, as these meters are usually
designed to
> operate between a range of frequencies, and that doesn't usually extend down
to
> the 2 to 4 Hz range.
>
> Now, looking closer at the schematic in front of me, I'm not certain that
> the pulsed
> output is used for silver generation. I'm typing out loud :-)
>
> The schematic I'm looking at has two output jacks: a 3.5mm jack labeled
"biological
> electrification" and an RCA jack labeled "colloids". The output from the RCA
jack
> appears to be fixed polarity DC with no active current limiting. There is a
150 ohm
> resistor and small lamp in series to limit the short circuit current only.
> This output
> would work nicely with a digital multimeter.
>
> So, maybe I'm not even on the right page!!!  I have Lyme Disease and
associated
> dane bramage...keep *that* in mind.
>
> Three things I know for sure:
>
> 1. Mike's idea of getting a multimeter is a good one, as he said, it is a
> very useful
>     tool and it will aid in understanding this electrical stuff.
>
> 2. Supper is ready.
>
> 3. The smoke alarms work!
>
> God Bless,
> Jeff
>


--
The silver-list is a moderated forum for discussion of colloidal silver.

To join or quit silver-list or silver-digest send an e-mail message to: 
[email protected]  -or-  [email protected]
with the word subscribe or unsubscribe in the SUBJECT line.

To post, address your message to: [email protected]
Silver-list archive: http://escribe.com/health/thesilverlist/index.html
List maintainer: Mike Devour <[email protected]>