A good way to compute the size of resistor needed for any current limiting
application: Use following 2 formulas V = I x R
P =
V x I
V= volts I = current (amps) R = resistance (ohms) P= power (watts)
Your worst case current, if computed for shorting out the electrodes, would
be the source voltage divided by the resistor you choose. So R = V divided
by I.
Example: for a 12 volt source to limit to 5 milliamps (.005 amps) the vaue
of R would be 2400 ohms. Now multiply 12V by .005A and you get .06 Watts,
the minimum power rating of your resistor.
Typically I make CS from silver wire and a $10 DC power supply you can get
from the consumer electronics stores. I always put a resistor in series to
avoid trashing the power supply in case the silver wires touch by accident.
-----Original Message-----
From: Katarina Wittich <[email protected]>
To: [email protected] <[email protected]>
Date: Monday, November 22, 1999 10:37 AM
Subject: CS>Re:Bil/resistor
>Hi Bil,
>that is exciting -- I would love to limit the current on my pulser.
>So do I buy a resistor at Radio Shack? and what exactly do I ask for?
>Then once I have it I just cut the wires and strip them a little and then I
>can wire in both the meter and the resistor? Can I wire the resistor to the
>meter and then the outside two wires to the pulser lead and the one to the
>electrode?
>
>I think I'm going to get all this stuff and start experimenting soon.
>
>Thanks for your help.
>Take care,
>katarina
>
>> Date: Sun, 21 Nov 1999 21:02:02 -0800
>> From: "2001 TV VCR" <[email protected]>
>> To: <[email protected]>
>> Subject: Re: CS>METERS & Current Limiting
>> Message-ID: <008e01bf34b7$069ee780$8dd4d...@x2001>
>> Content-Type: text/plain;
>> charset="iso-8859-1"
>> Content-Transfer-Encoding: 7bit
>>
>> To Jeff and all,
>>
>> The output of the Bob Beck approved pulsers/
>> CS makers is 27 VDC (pure DC, no pulsing) if
>> you use the correct jack (CS).
>>
>> To limit the current to a maximum of 2 to 3 mA
>> (depends on how strong you make the CS)
>> when using 27 or 30 VDC just wire a 8200 ohm
>> resistor (any wattage will do) in series with one
>> of the leads going to the silver.
>>
>> Don't worry about cutting one of the wires to
>> wire in the resistor and your meter (mA scale).
>> This will not affect the operation in any way
>> other than to limit the current (resistor). The
>> benefits far outweigh the slight damage (change
>> of appearance!).
>>
>> If you still have questions let me know.
>> Good luck,
>>
>> Bil
>
>
>--
>The silver-list is a moderated forum for discussion of colloidal silver.
>
>To join or quit silver-list or silver-digest send an e-mail message to:
>[email protected] -or- [email protected]
>with the word subscribe or unsubscribe in the SUBJECT line.
>
>To post, address your message to: [email protected]
>Silver-list archive: http://escribe.com/health/thesilverlist/index.html
>List maintainer: Mike Devour <[email protected]>
>