Say it isn't so!

Our benchmark does not have feet of clay.

James Osbourne Holmes

FTNWO

-----Original Message-----
From: Ivan Anderson <[email protected]>
To: [email protected] <[email protected]>
Date: Monday, April 17, 2000 3:55 PM
Subject: Re: CS>Hanna meter


>Fred,
>
>No, I have been consistent as far as I know.
>0.57 uS / ppm is the conductance of discrete silver ions.
>The relationship changes from this point, depending upon the physical
>description of the colloid. As the colloid particles become larger, so
>does the conductivity reading. Where your or someone else's CS fits
>along this line (0.5 to >2.0 uS per ppm) is guess work unless the
>actual ppm is independently tested. However, if you have a clear
>solution with little Tyndal then it is likely to be ~ 1 to 1
>relationship. If coloured with a strong Tyndal then closer to 2uS per
>ppm.
>
>As I said at the outset of this discussion, conductivity measurements
>are only reliable within certain perimeters, but are certainly useful
>for batch to batch measurement and water quality testing.
>
>All I can give you is the benefit of my experience and study, but I
>make no claims other than to note that what I say is what I believe. I
>have been wrong and plain stupid in the past.
>
>Good health
>Ivan.
>
>----- Original Message -----
>From: "Fred" <[email protected]>
>To: <[email protected]>
>Sent: Tuesday, 18 April 2000 05:12
>Subject: Re: CS>Hanna meter
>
>
>> Ivan, you are flipping back and forth on the uS/PPM issue - can you
>> define a little more your numbers vs. material tested. Below you
>agree
>> with K Watson that 1.8uS/PPM may be correct (if heavy Tyndall) or as
>> low as 1uS/PPM (if not heavy?) yet in a post  minutes earlier you
>revert
>> to the 0.59uS/PPM based on silver nitrate in solution.
>>
>> A lot of us rely on your technical expertise, and those not
>following all
>> your posts will get off to different "correct" values! I realize you
>consider
>> TDS to be particle size dependent but what would help is your
>opinion
>> on the conversion for "typical" Cs. It is nice being an agreeable
>chap,
>> but now we can't argue "But Ivan said...."
>>
>> Thanks, [email protected]
>>
>> Ivan said: K. Watson,
>>
>> I should think that if you have a heavy Tyndal effect then that
>could
>> be the case. Otherwise the concentration could be as high as 10ppm.
>> If you have a consistent generating regime then perhaps having one
>or
>> two samples professionally tested would give you a good benchmark.
>>
>> Ivan.
>>
>> ----- Original Message -----
>> From: "James K. Watson" <[email protected]>
>> To: <[email protected]>
>> Sent: Friday, 14 April 2000 11:55
>> Subject: Re: CS>Hanna meter
>>
>>
>>  > Ivan,
>>  >  I have the Hanna PWT. If I have a reading of 10.0 on the meter
>this
>> means
>>  > the solution is about 5.5 PPM. Is this correct ?
>>  >                                                       K. Watson
>
>
>--
>The silver-list is a moderated forum for discussion of colloidal silver.
>
>To join or quit silver-list or silver-digest send an e-mail message to: 
>[email protected]  -or-  [email protected]
>with the word subscribe or unsubscribe in the SUBJECT line.
>
>To post, address your message to: [email protected]
>Silver-list archive: http://escribe.com/health/thesilverlist/index.html
>List maintainer: Mike Devour <[email protected]>
>
>