What about doing the same thing using more voltage? I have a 15V adaptor I could "butcher" to try this method with...
for those who are reluctant generate at 110 Volt or 240 Volt, here is a description of a very simple but most effective low voltage generator I have developed. The circuit operates at about 12 V DC. Parts: 1 x 9 Volt DC 200 mAmp (amperage doesn't matter, this was the cheapest), AC mains adaptor. 2 x alligator clips Method: 1. Chop the DC socket off the mains adaptor. 2. Split the lead for a couple of inches, strip the ends and attach the alligator clips. 3. Plug the adaptor into the wall. 4. Secure the alligator clips to your silver wire, place in distilled water (keep clips dry). 5.Switch on. Thats all... I have tested this arrangement, and it produces 10 PPM (+ or - 2) CS: in hot d. water ------ 1.5 hrs in cold d. water ------ 3.0 hrs in 1cup (200mls, 7 - 8 oz) distilled water, with electrodes in the following arrangement, 2 x 2mm silver wire (14swg), wetted depth 45mm (1 3/4"), 45mm apart. I used a sterilite 1 cup, soft clear lidded plastic container with the electrodes pushed through the lid and parallel. The container dimensions are, 85mm (3 1/4") diameter by 65mm (2 1/2") deep. Colloidal Silver produced in this manner is clear (cold water) or has a slight yellow tinge (hot water) and needs no filtering. There is little metallic build up on the cathode (no trees etc.) and little black build up on anode. The plastic container will develop a yellowish tinge after a few batches, which will not wipe off. This is not a problem, and may in fact serve to isolate the colloid from static build up. I give the container a *swirl* every half hour or so. I wipe the cathode (grey) after I am finished and leave the anode (black) alone. Can't think of anything else... Hope this is of help to someone. Regards - Ivan.>>> -- The silver-list is a moderated forum for discussion of colloidal silver. To join or quit silver-list or silver-digest send an e-mail message to: silver-list-requ...@eskimo.com -or- silver-digest-requ...@eskimo.com with the word subscribe or unsubscribe in the SUBJECT line. To post, address your message to: silver-list@eskimo.com Silver-list archive: http://escribe.com/health/thesilverlist/index.html List maintainer: Mike Devour