Try a pencil eraser.It brings the copper pennies on my
Terminator Zapper to a shine.My CS maker uses a 1oz
silver ingot & i put it under running water after i brew a gallon & wipe off
with Q tips,never letting the silver ingot
dry out before cleaning it.
----- Original Message -----
From: "Marshalee" <mama...@netzero.net>
To: <silver-list@eskimo.com>
Sent: Tuesday, June 28, 2005 2:50 PM
Subject: CS>Re: CS cleaning Electrodes
Paper towel works for me. Occasionally I use a blue scrubber to polish `em
up.
Marshalee
List,
I clean my silver electrodes with a very fine sand paper until they
shine.
Frank
----- Original Message -----
*From:* Medwith, Robert <mailto:robert.j.medw...@us.army.mil>
*To:* 'cs' <mailto:silver-list@eskimo.com>
*Sent:* Tuesday, June 28, 2005 12:20 PM
*Subject:* CS>CS Electrodes
I personally never clean my electrodes, I have a CS generator that
reverses current as it works.
The electrodes do get dirty but I figure the filter will catch it.
I just run each Gallon batch through 4 layers of brown (not
bleached) coffee filter.
I have a plastic hose 1/4 inch with plastic valve on end.
I drip the CS through the filters slowly.
I make batches from to 50 PPM and it all is and stays clear.
Bob
--
The Silver List is a moderated forum for discussing Colloidal Silver.
Instructions for unsubscribing are posted at: http://silverlist.org
To post, address your message to: silver-list@eskimo.com
Silver List archive: http://escribe.com/health/thesilverlist/index.html
Address Off-Topic messages to: silver-off-topic-l...@eskimo.com
OT Archive: http://escribe.com/health/silverofftopiclist/index.html
List maintainer: Mike Devour <mdev...@eskimo.com>
