Hi, forum. After a few years out, I decided to put simh-vax up again. Since my old files were lost on an old desktop, now I am setting simh-vax on a laptop with eth0 and wlan0, as network interfaces. My first goal was just to put vax-vms running again. That's ok. VAX-VMS073 with ethernet support installed. Now, trying to get telnet working, after insert licenses and install tcpip, I stuck with simh networking again. Following docs on simh-3.9 (readme_ethernet-howto), I did:
-my LAN 192.168.25.0 - wlan0 192.168.25.23 - eth0 not in use. -linux side: -after setting up a tuntap tap0 is available. -bridging: br0 ip address 192.168.25.100/24 with eth0(ip 0.0.0.0) and tap0(ip 0.0.0.0) -at this point doesnt matter simh connections outside my lan. -(simh)vax-vms side: -xqa0 attached to eth0 (QE0 ip 192.168.25.200) and -xqb0 attached to tap:tap0 (QE1 ip 192.168.25.220). No success. -trying with xqa0 disabled on vms side:no success I've checked and tryied to set QE0 to ip 0.0.0.0, with no success (invalid address under vms). So I cant figure out how to put vms talking to host via tcpip. Even after several trying on bridging. Build vax with no problem; bootting and installing VMS073 with no problem too. Using simh-3.9.0 (although show version reports me simh-4.0 beta) OS linux slackware64 14.1(with multilib) Any help welcome. thanks. marx -- T+ []´s marx :-p
_______________________________________________ Simh mailing list [email protected] http://mailman.trailing-edge.com/mailman/listinfo/simh
