On Tuesday, May 9, 2017 at 10:15 AM, Alan Perry wrote: > I am participating in the UUCP project and have set up a SIMH vax750 on a > Raspberry Pi. I am using the 4.3BSD bits that the UUCP project lead > (Warren) provides to install the system and followed his instructions for > configuring it. > > It uses a simulated hard-wired serial connection to communicate with a > remote simulated host over TCP/IP. However, I have not been able to make > this connection work. Everything seems good on the simulated VAX. But when > I initiate connections to the remote host, I see no corresponding activity on > my network. > > Any suggestions of specific things to check to figure out why nothing is going > out to the network?
To start understanding what is going on, please provide: 1) the output of SHOW VERSION executed at the sim> prompt of your simulator. 2) the same for the remote simulator. 3) The configuration that is being used on BOTH simulators - Mark _______________________________________________ Simh mailing list Simh@trailing-edge.com http://mailman.trailing-edge.com/mailman/listinfo/simh
