THese guys had been quite for a bit. I have 100's of messages in the que that are from [EMAIL PROTECTED] to [EMAIL PROTECTED] or [EMAIL PROTECTED] to [EMAIL PROTECTED] and many more random to and from addresses. I can find in the logs where the mail is accepted from [EMAIL PROTECTED] It is in the que suspended going to [EMAIL PROTECTED] I can not find [EMAIL PROTECTED] in the logs.
There are also tons of failed messages. I can find the mail that failed. Here is a clip of the logs for the two examples above. How do i make them stop. And how are they doing it?
Did you see the response to your last question about this? I'm mailing both you and the list to make sure you see this one.
Basically you need to do 2 things:
1. Make sure you have "Relay for clients only" checked in the SMTP config.
2. Increase logging in the SMTP, Router, and General settings to "Low Level" or "All Info"
Without #1 you will stop no relay at all. Without #2 there is no hope of diagnosing how the relay is being done. I'm not convinced from the log snippets that you gave that it really IS being done.
--
Bill Cole [EMAIL PROTECTED]
############################################################# This message is sent to you because you are subscribed to the mailing list <[EMAIL PROTECTED]>. To unsubscribe, E-mail to: <[EMAIL PROTECTED]> To switch to the DIGEST mode, E-mail to <[EMAIL PROTECTED]> To switch to the INDEX mode, E-mail to <[EMAIL PROTECTED]> Send administrative queries to <[EMAIL PROTECTED]>
