Hi Harald,
Well it looks like my attempt to solder header pins onto the board has
ended in a disaster:
I'm now seeing this when I connect the USB.
Jun 3 09:23:23 kageds kernel: [1094465.891611] usb 1-1: new low-speed
USB device number 71 using xhci_hcd
Jun 3 09:23:23 kageds kernel: [1094466.011674] usb 1-1: device
descriptor read/64, error -71
Jun 3 09:23:23 kageds kernel: [1094466.239641] usb 1-1: device
descriptor read/64, error -71
Jun 3 09:23:23 kageds kernel: [1094466.467689] usb 1-1: new low-speed
USB device number 72 using xhci_hcd
Jun 3 09:23:23 kageds kernel: [1094466.587703] usb 1-1: device
descriptor read/64, error -71
Jun 3 09:23:23 kageds kernel: [1094466.815730] usb 1-1: device
descriptor read/64, error -71
Jun 3 09:23:24 kageds kernel: [1094466.923737] usb usb1-port1: attempt
power cycle
Jun 3 09:23:24 kageds kernel: [1094467.567751] usb 1-1: new low-speed
USB device number 73 using xhci_hcd
Jun 3 09:23:24 kageds kernel: [1094467.568257] usb 1-1: Device not
responding to setup address.
Jun 3 09:23:24 kageds kernel: [1094467.776277] usb 1-1: Device not
responding to setup address.
Jun 3 09:23:25 kageds kernel: [1094467.983753] usb 1-1: device not
accepting address 73, error -71
Jun 3 09:23:25 kageds kernel: [1094468.103767] usb 1-1: new low-speed
USB device number 74 using xhci_hcd
Jun 3 09:23:25 kageds kernel: [1094468.104244] usb 1-1: Device not
responding to setup address.
Jun 3 09:23:25 kageds kernel: [1094468.312219] usb 1-1: Device not
responding to setup address.
Jun 3 09:23:25 kageds kernel: [1094468.519831] usb 1-1: device not
accepting address 74, error -71
Jun 3 09:23:25 kageds kernel: [1094468.520812] usb usb1-port1: unable
to enumerate USB device
I also just see garbage on both debug ports. Though I'm not sure which
is pin1 on the headers or what baud rate I should be using.
I'm guessing I should send the board back for repair?
Any thoughts
Thanks
Alan
On 31/05/2019 15:08, Harald Welte wrote:
Hi Alan,
On Fri, May 31, 2019 at 11:02:50AM +0100, KageDS wrote:
FYI The pins are missing on X601 and X701. Looks like I need to dig up some
header pins as well.
yes, this is intentional. The pin headers were impacting some enclosure
ingtegration
of a customer, and we decided to not place them by default. After all, they're
not
for use in production.
I guess we could place them for the 1-off evaluation board purchases, thanks for
pointing that out.
