As stated earlier, Cisco TAC will most likely say that they do not support it on anything other than Cisco. Sen, Do you have any contacts at Cisco that may provide assistance with the messages below?
Jes -----Original Message----- From: Scott Lawrence [mailto:[email protected]] Sent: Friday, March 20, 2009 10:53 AM To: Becker, Jesse Cc: [email protected] Subject: RE: [sipX-dev] Polycoms will not call Ciscos On Fri, 2009-03-20 at 10:20 -0400, Becker, Jesse wrote: > All, > This is the error the Cisco phone flags with firmware 8-3x and higher: > ERR 10:07:22.517069 JVM: sipSPICheckRequest: Content header value not supported > ERR 10:07:22.518008 JVM: SIPTaskProcessSIPMessage: Error: sipSPICheckRequest() returned error. > > That is when the cisco phone sends > 406 "Not Acceptable" response to the INVITE. The two Content* headers in the trace you sent look just fine. I checked the Content-Length and it was correct, and the Content-Type is just application/sdp. > Any ideas? Firmware 8-2-2 does not reject the call, however, we have an issue that 8-2-2 has buggy WMI. Ask Cisco? _______________________________________________ sipx-dev mailing list [email protected] List Archive: http://list.sipfoundry.org/archive/sipx-dev Unsubscribe: http://list.sipfoundry.org/mailman/listinfo/sipx-dev
