Hello,

When running the cd created with mkautoinstallcd I ran into trouble; eth0 doesnt come up.
Configuring the device by hand on the busybox shell does work. So after some searching I found that the rcS script can't use my simple $DEVICE eth0.
So when I change:


288    start_network() {
289     if [ ! -z $IPADDR ]; then
290
291         # configure interface and add default gateway
292         ifconfig $DEVICE $IPADDR  netmask $NETMASK  broadcast $BROADCAST
293         if [ $? != 0 ]; then

The line 292 to:

292 ifconfig eth0 $IPADDR netmask $NETMASK broadcast $BROADCAST

It works after changing that, but I'am puzzled on the why part (?).

(I did validate that the $DEVICE is present by just echoing before the 292 line...)

I'am using SIS 3.0.1-1 with the local.cfg on a fat 1.44 floppy.

Best regards,
Leroy van Logchem


PS: After this step is hopefully solved I'll continue to get the I2O scsi devices to work :P , but that's another party in my near future. :)




-------------------------------------------------------
This SF.Net email sponsored by: Free pre-built ASP.NET sites including
Data Reports, E-commerce, Portals, and Forums are available now.
Download today and enter to win an XBOX or Visual Studio .NET.
http://aspnet.click-url.com/go/psa00100006ave/direct;at.asp_061203_01/01
_______________________________________________
Sisuite-users mailing list
[EMAIL PROTECTED]
https://lists.sourceforge.net/lists/listinfo/sisuite-users

Reply via email to