> Pessoal,
>
> Instalei Slack 9.1 em uma m�quina com uma controladora SCSI Adaptec 29160
> (AIC7xxx).
>
> O problema � o seguinte, qdo o Slack inicia emite o seguinte erro:
>
> insmod /lib/modules/2.4.22/kernel/drivers/scsi/aic79xx.o.gz: failed
>
> insmod erros can be caused by incorrect modules or parameters. Including
> invalid IO or IRQ parameters
>
> insmod /lib/modules/2.4.22/kernel/drivers/scsi/aic7xxx.o.gz: failed
>
> insmod erros can be caused by incorrect modules or parameters. Including
> invalid IO or IRQ parameters
>
> Duas observa��es, est� funcionando direitinho (aparentemente) e a
> placa � PCI, ent�o IO e IRQ acredito que n�o deva ser o problema.
>
> Algu�m sabe do que se trata?
>
scsi0 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.2.28
<Adaptec 29160 Ultra160 SCSI adapter>
aic7892: Ultra160 Wide Channel A, SCSI Id=7, 32/253 SCBs
nesta maquina ( 2.4.21-pre7) , as opcoes no kernel deste modulo , estao assim:
<*> Adaptec AIC7xxx support
(32) Maximum number of TCQ commands per device
(15000) Initial bus reset delay in milli-seconds
[ ] Probe for EISA and VL AIC7XXX Adapters
[ ] Build Adapter Firmware with Kernel Build
[ ] Compile in Debugging Code
(0) Debug code enable mask (2048 for all debugging)
[ ] Decode registers during diagnostics
Talvez abilitando as opcoes de debug, teus logs te mostrem algo mais.
> Obrigado
>
> Danilo
>
[]�s
--
GUS-BR - Grupo de Usu�rios Slackware - BR
http://www.slackwarebrasil.org/
http://www.linuxmag.com.br/mailman/listinfo/slack-users
