Abro essa duvida apos diversos testes e em resposta ao amigo Lopan esclareco:
*Olá Alcir. Ip voce pode setar editando o arquivo /etc/rc.d/rc.inet1 Como por exemplo pra deixar fixo o IP na interface eth0: DEVICE='eth0'* * DHCP='no' IPADDR='192.168.2.1' NETMASK='255.255.255.0' GATEWAY=''* *PROBE='no' * Tenho um sistema 13.37 instalado numa placa mae Asus A8V-MX. Transportei o hd para outra placa de mesmo modelo e editei o * # /etc/udev/rules.d/70-persistent-net.rules* ( name para eth0 ) apos configurar o ip via com as alternativas * # netconfig * ou manualmente com * #ifconfig eth0 201.37.x.xxx netmask 255.255.255.0 up* tenho conex'ao com a internet.* Porem apos o reboot eu perco o ip*. O modulo esta carregado e certifico com: *#depmod -a* ( nehuma saida ) *#lspci* ( mostra-me via_rhine e mii como ethernet ) *#lsmod *( parte da saida ) Module Size Used by vboxnetadp 6727 0 ... via_rhine 17845 0 mii 3334 1 via_rhine ipv6 236629 14 * # dmesg *( onde encontrei coisas que desconheco ) [ 0.235872] pci 0000:00:13.0: PCI bridge to [bus 04-04] [ 0.236004] pci 0000:00:13.0: bridge window [io 0xf000-0x0000] (disabled) [ 0.236009] pci 0000:00:13.0: bridge window [mem 0xfbf00000-0xfbffffff] [ 0.236015] pci 0000:00:13.0: bridge window [mem 0xfff00000-0x000fffff pref] (disabled) [ 0.236080] pci 0000:00:13.1: PCI bridge to [bus 05-05] (subtractive decode) [ 0.236179] pci 0000:00:13.1: bridge window [io 0xf000-0x0000] (disabled) [ 0.236184] pci 0000:00:13.1: bridge window [mem 0xfff00000-0x000fffff] (disabled) [ 0.236190] pci 0000:00:13.1: bridge window [mem 0xfff00000-0x000fffff pref] (disabled) [ 0.236194] pci 0000:00:13.1: bridge window [io 0x0000-0xffff] (subtractive decode) [ 0.236197] pci 0000:00:13.1: bridge window [mem 0x000a0000-0x000bffff] (subtractive decode) [ 0.236201] pci 0000:00:13.1: bridge window [mem 0x20000000-0xffffffff] (subtractive decode) [ 0.236224] pci_bus 0000:00: on NUMA node 0 [ 0.236228] ACPI: PCI Interrupt Routing Table [\_SB_.PCI0._PRT] [ 0.236382] ACPI: PCI Interrupt Routing Table [\_SB_.PCI0.P0P7._PRT] [ 0.236412] ACPI: PCI Interrupt Routing Table [\_SB_.PCI0.P0PA._PRT] [ 0.236498] ACPI: PCI Interrupt Routing Table [\_SB_.PCI0.P0P1._PRT] [ 0.236529] ACPI: PCI Interrupt Routing Table [\_SB_.PCI0.NBPG._PRT] [ 0.236566] ACPI: PCI Interrupt Routing Table [\_SB_.PCI0.NBP0._PRT] [ 0.249347] ACPI: PCI Interrupt Link [LNKA] (IRQs 3 4 *5 6 7 10 11 12 14 15) [ 0.250064] ACPI: PCI Interrupt Link [LNKB] (IRQs 3 4 5 6 7 10 *11 12 14 15) [ 0.250769] ACPI: PCI Interrupt Link [LNKC] (IRQs 3 *4 5 6 7 10 11 12 14 15) [ 0.251468] ACPI: PCI Interrupt Link [LNKD] (IRQs 3 4 *5 6 7 10 11 12 14 15) [ 0.252187] ACPI: PCI Interrupt Link [LNKE] (IRQs 3 4 5 6 7 10 11 12 14 15) *0, disabled. [ 0.253043] ACPI: PCI Interrupt Link [LNKF] (IRQs 3 4 5 6 7 10 11 12 14 15) *0, disabled. [ 0.253884] ACPI: PCI Interrupt Link [LNKG] (IRQs 3 4 5 6 7 10 11 12 14 15) *0, disabled. [ 0.254707] ACPI: PCI Interrupt Link [LNKH] (IRQs 3 4 5 6 7 *10 11 12 14 15) [ 0.255411] HEST: Table is not found! ... [ 0.310611] RPC: Registered tcp NFSv4.1 backchannel transport module. [ 0.310711] pci 0000:00:00.0: MSI quirk detected; MSI disabled [ 0.310827] pci 0000:00:01.0: disabling DAC on VIA PCI bridge [ 0.310925] pci 0000:00:02.0: MSI quirk detected; subordinate MSI disabled ... [ 4.192627] via-rhine.c:v1.10-LK1.4.3 2007-03-06 Written by Donald Becker [ 4.192784] via-rhine 0000:00:12.0: PCI INT A -> GSI 23 (level, low) -> IRQ 23 [ 4.202762] rtc_cmos 00:02: RTC can wake from S4 [ 4.203527] rtc_cmos 00:02: rtc core: registered rtc_cmos as rtc0 [ 4.203661] rtc0: alarms up to one year, y3k, 114 bytes nvram [ 4.204425] eth0: VIA Rhine II at 0xf8fff800, 00:11:d8:01:23:45, IRQ 23. [ 4.205234] eth0: MII PHY found at address 1, status 0x786d advertising 01e1 ... [ 11.692128] EXT4-fs (sda6): mounted filesystem with ordered data mode. Opts: (null) [ 13.986540] eth0: link up, 100Mbps, full-duplex, lpa 0x45E1 [ 15.200684] NET: Registered protocol family 10 [ 15.200937] lo: Disabled Privacy Extensions [ 25.938014] eth0: no IPv6 routers present [ 46.132279] vboxdrv: Found 1 processor cores. [ 46.135986] vboxdrv: TSC mode is 'synchronous', kernel timer mode is 'normal'. [ 46.135991] vboxdrv: Successfully loaded version 4.0.8_OSE (interface 0x00180000). [ 55.690230] start_kdeinit (2089): /proc/2089/oom_adj is deprecated, please use /proc/2089/oom_score_adj instead *Curiosamente, o comando */etc/rc.d/rc.inet1 eth0_start em rc.d/rc.local n'ao funciona logo apos o reboot. Mas no console faz o ping para o servidor funcionar.* Alguma ideia? * -- GUS-BR - Grupo de Usuários de Slackware Brasil http://www.slackwarebrasil.org/ http://groups.google.com/group/slack-users-br Antes de perguntar: http://www.istf.com.br/perguntas/ Para sair da lista envie um e-mail para: [email protected]
