Can this answer your question? http://www.dmzinabox.com/support/faqs/showfaq.php?item=Should%20I%20use%20public%20or%20private%20IP%20addresses%20in%20the%20DMZ%20security%20zone
On 17 May 2010 14:59, M K Saravanan <[email protected]> wrote: > Hi, > Need help on setting up firewall router (using vyatta community edition). > My config is as below: > Public static network ID: x.x.x.48/28 > gateway: x.x.x.49 > available IP for the hosts: x.x.x.52 to 62 > > gw_eth0 <--> fw_eth0 - fw_eth1 <--> dmz_switch > Four servers are connected on dmz_switch (say s1, s2, s3, s4) all have to > use public static IP address from the above block. > Any recommendation on IP assignment and route setup? Do I need to subnet > the above block further or simply use /32 netmask and point-to-point static > routes in the above setup? > > with regards, > mks > > _______________________________________________ > LUGS Mailing list - [email protected] > List FAQ: http://wiki.lugs.org.sg/LugsMailingListFaq > Info page: http://www.lugs.org.sg/mailman/listinfo/slugnet > To unsubscribe send an empty email to: [email protected] > > _______________________________________________ LUGS Mailing list - [email protected] List FAQ: http://wiki.lugs.org.sg/LugsMailingListFaq Info page: http://www.lugs.org.sg/mailman/listinfo/slugnet To unsubscribe send an empty email to: [email protected]
