I absolutely agree. Sully
-----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Scott Damron Sent: Thursday, July 10, 2003 10:06 AM To: [EMAIL PROTECTED] Subject: RE: [smartBridges] POE flakey??? Yes, I have seen this as well. I replaced the power supply with one from Radio Shack and it was a little better, however, I think it has to do with the inside of the connector on the POE side. I could be wrong, but that is what it looked like to me. Scott -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Mark P. Sullivan Sent: Thursday, July 10, 2003 9:46 AM To: [EMAIL PROTECTED] Cc: [EMAIL PROTECTED] Subject: [smartBridges] POE flakey??? sB...this may be something for you to look at closely. I was troubleshooting a clients bad airBridge unit last night and noticed something flakey about the POE unit. Hope I can describe it... If you follow the wall plug wire up to the point where you can connect/disconnect it from the POE unit there is a chrome plug. Out of the box, this is initially unplugged. While you are looking at your connected/associated sB product...hold that chrome power plug in both hands (one on the power plug side and one on the POE side) and twist it 360 degrees around axis. You will notice that the power goes on and off. I did very small tweaks (rotating the chrome plug around axis) until I actually found a spot that would cause the sB unit to go (and stay) offline (noticed the Ethernet 10 Meg connection go offline "Cable Unplugged"). I then tweaked it a bit away from that position and it would go back online ("10 Meg Cable connected"). I was logged into the sB product (in my case airBridge), and when I would twist this connector, it would lose association (obviously...due to loss of power) and then twist it back and it would reassociate. I tried this with several POE units and power cables. All with the same results. Given some more time, I will have to check the POE power pins and see if there are "sweet spots" on this chrome plug that allow the full 12 volts to pass. Or vice versa. Can someone else confirm my findings please?? Sully The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org
