Re: [smartBridges] MORE ABOS crapping out

Wed, 20 Aug 2003 09:12:22 -0700

probably that virus is a bitch I was up all night at my regular job with the telco listening to the network people work on it all night.
 
Here is a question can I pull SNMP info from each radio I have this software that I think might work is there specific port that it needs to listen to for the radio info or do I have to set it up to go retrieve it?
 
 
Seems like pretty cool software..
 
----- Original Message -----
Sent: Wednesday, August 20, 2003 9:05 AM
Subject: RE: [smartBridges] MORE ABOS crapping out

I have yet to receive a new order of the REPLACED CHIPSET.  I have only been receiving the �DEFECTIVE� chipset plus firmware.  Yes�I used the word DEFECTIVE appropriately.

 

sB is VERY quiet today.  They must be getting hammered by all the VIRUSES/WORMS!  (-;

 

Sully

 

-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Blazen Wireless
Sent: Wednesday, August 20, 2003 8:56 AM
To: [EMAIL PROTECTED]
Subject: Re: [smartBridges] MORE ABOS crapping out

 

thats funny I run a ping log on my system when they systems go down it is 0930PT -1700PT about the same times you are describing? did the firmware or chip change lower the threshold on how much heat these things can handle??

 

 

----- Original Message -----

Sent: Wednesday, August 20, 2003 8:48 AM

Subject: RE: [smartBridges] MORE ABOS crapping out

 

I have 25 clients off of my repeater (aPPo in access point mode) which connects back to my head-end via an indoor airPoint.  My head-end has 24 clients plus the repeater locations (2 of them) which is 26 associated.  If you include the users on the other side of the repeaters, I have a total of 52 clients going through my head-end aPPo.

 

Everything was fine with my head-end until I put up one of the new (bad chipset) units.  It now will drop ALL my users are random times (normally between 10 am and 5 pm).  It only gets up to 80 degrees here�so heat shouldn�t be an issue.

 

My repeater with 25 clients on it�works flawlessly!  It is an older aPPo with the hardwired CAT5 attached.

 

Sully

 

-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Blazen Wireless
Sent: Wednesday, August 20, 2003 7:44 AM
To: [EMAIL PROTECTED]
Subject: Re: [smartBridges] MORE ABOS crapping out

 

I notice that when I get 21-22 users and sometimes 23 is the max that seems to be able to associate to the APPO before I start seeing the dissociation problems.

----- Original Message -----

Sent: Wednesday, August 20, 2003 7:32 AM

Subject: [smartBridges] MORE ABOS crapping out

 

Okay I give up I have 4 of the new radios I purchased with supposedly the new chi and the new firmware and they are still disassociating any wonderful ideas on what to try next.

 

1. I have tried everything I have tried in the past when this whole thing started so PLEASE SB don't tell me stupid stuff to check already since I know 100% it is not the installation.

2. When we went to look at the one yesterday it was thought to be heat related. We touched the ABO and it was Luke warm if at hottest. Link light (blue) was just flashing away NO association. RSSI 85% Link 95% GREAT signal and he keeps losing associating every day.

 

PLEASE PLEASE PLEASE let us know what's causing this.

 

This customer is hooked from the radio to a D-link 4 port router to his laptop as are most all my installs..

 

 

 

 

Reply via email to