Not for a week, but a few days....it might be the APPO, it's just that hours before it was put up there, it worked on a short cable on the ground. ----- Original Message ----- From: "Pascal Losier" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Tuesday, September 09, 2003 2:02 PM Subject: RE: [smartBridges] Long Ethernet runs...
> Did you try this APPO for a week or so before installing it ?? > > I might be the APPO > > > > > > > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of Rudolph Worrell > Sent: Tuesday, September 09, 2003 2:25 PM > To: [EMAIL PROTECTED] > Subject: RE: [smartBridges] Long Ethernet runs... > > > I would check your ethernet card and see if it is set to 100 or 10 or to > auto sensing. I have seen this with a dell built in ethernet card and I > had to force it to 10mbps instead of auto. This is just a quick > thought. It may very well be a result of the long run. > > > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] Behalf Of Patrick > Sent: Tuesday, September 09, 2003 12:10 PM > To: [EMAIL PROTECTED] > Subject: [smartBridges] Long Ethernet runs... > > > We just finished mounting our new setup 220 ft up on a spectrasite tower > and I seem to be having wierd issues with an AP Total. The ethernet > connectivity randomly drops. I have my laptop plugged directly into it > and it will work for a few minutes then show disconnect and then come > back etc. I figured it was probably due to using the stock 12volt wall > wart. I bought some radio shack 18v 1amp units and when I plug them in, > the powershot unit's light looks flaky. It almost looks like it is > flashing really fast. I tried 3 different units, both neg tip and > positive tip. I put the 12 volt back and the light it good, but the > unit keeps dropping the ethernet. Any ideas? Anyone use the Radio > Shack units for long runs? > > Patrick > > ----------ANNOUNCEMENT---------- > Don't forget to register for WISPCON IV > http://www.wispcon.info/us/wispcon-iv/wispcon-iv.htm > > The PART-15.ORG smartBridges Discussion List > To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe > smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in > the body type unsubscribe > smartBridges) > Archives: http://archives.part-15.org > > ----------ANNOUNCEMENT---------- > Don't forget to register for WISPCON IV > http://www.wispcon.info/us/wispcon-iv/wispcon-iv.htm > > The PART-15.ORG smartBridges Discussion List > To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe > smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in > the body type unsubscribe smartBridges) > Archives: http://archives.part-15.org > > > > > ----------ANNOUNCEMENT---------- > Don't forget to register for WISPCON IV > http://www.wispcon.info/us/wispcon-iv/wispcon-iv.htm > > The PART-15.ORG smartBridges Discussion List > To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> > To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) > Archives: http://archives.part-15.org ----------ANNOUNCEMENT---------- Don't forget to register for WISPCON IV http://www.wispcon.info/us/wispcon-iv/wispcon-iv.htm The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org
