Title: Message
|
If you
place router an have multiple subnet, & have implemented PPPOE with
mikrotik.
Do you
need a PPPOE server at each router ??? or just set up 1 PPPOE server
at the NOC.
Just putting a switch
in wont do it. The suggestion was
a switch at each point
in the network that supports VLAN
tagging.
You are better off
routing. It isolates the broadcasts to
that portion of the
network so it doesn't take your entire
network down. (or slow
it significantly)
How to tell? MANY MANY
MANY small packets with a destination
of your broadcast
address on that network segment.
so just added any unmanaged cheap switch
between the two will stop any broadcast traffic? How can you tell if you are
being affected by broadcast problems or any other problems you get with a
bridged network? I do not have problems now but would like to know what to
look for.
Thank you,
Jerry
----- Original Message -----
Sent: Sunday, October 05, 2003 12:16
PM
Subject: RE: [smartBridges] Bridged
verses routed?
You can prevent
the broadcast traffic by two ways.
- Having a
router between the CB and the aPPO,
- or creating
VLAN’s by using switches at every POP.
Vasu
-----Original
Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] On Behalf Of Jerry Carter
Sent: Monday, October
06, 2003 12:18 AM
To: [EMAIL PROTECTED]
Subject: [smartBridges] Bridged
verses routed?
Ok I am wondering
the best way here. I require all my clients to run a router at there
location(Dlink DI-604). I have seen people talk about this topic and say
its much better to run a network that has routers at each access point
site. If all my clients have a router is it ok to just do a client bridge
and access point as a repeater? Will the broadcast storms and such be
stopped because my clients have a router at each location or could
this still become a problem in the future because of the way I am setting
up access points without any routing involved? Should I be adding a router
in between each client bridge appo and the access point
appo?
|
