1. AirPoint01 and AirPoint02 on Channel "1" "Use a different network address/mask scheme for the backhaul"
2. Add a Cisco or other quality router at the Airpoint02-03 location. Setup routing for the two networks, This will contain/prevent broadcast storms onto your bridged backhaul. 3. AirPoint03 AccessPoint mode on Channel "11" "Use a different network address/mask scheme for the AP/Client network. Describe more your problem of: We have only intermittent connections with the units. Are you getting timeouts, etc. Mike -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Behalf Of Mikkel Andreasen Sent: Friday, October 17, 2003 4:50 AM To: [EMAIL PROTECTED] Subject: [smartBridges] Setup of new AirPoint bridges hi all, I tried to send this mail yesterday, but it appears that something went wrong. If it did show up, I apologize for the double posting. I need som advice on the following setup: Office roof: AirPoint Pro Total in Point-to-Point wireless bridge mode (AirPoint01 <-> AirPoint02) Mast on hilltop: AirPoint Pro Total in Point-to-Point wireless bridge mode (AirPoint02 <-> AirPoint01) AirPoint Pro Outdoor in Accesspoint mode with 14 dbi gain antennas (AirPoint03) Homeoffice Airbridge with 9 dbi gain antenna (2 km away from the mast) AirPoint01 and AirPoint02 are set up as wireless bridges with each others MAC adresses. AirPoint02 and AirPoint03 are connected by 2 75 feet PDS cables ending in a small hut next to the antenna. All units are powered by the standard 12 volt powersupply. Problem: We have only intermittent connections with the units. Question: Which modes should the units be set at? Especially AirPoint03. Should it be Wireless Repeater or perhaps Point-to-Multipoint? Sincerely Mikkel Andreasen ----------ANNOUNCEMENT---------- Don't forget to register for WISPCON IV http://www.wispcon.info/us/wispcon-iv/wispcon-iv.htm The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org ----------ANNOUNCEMENT---------- Don't forget to register for WISPCON IV http://www.wispcon.info/us/wispcon-iv/wispcon-iv.htm The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org
