Hi! We run RADIUS auth on all of ours AAPO's?? SimpleMonitor 1.6 anf Firmware 1.4j.9
I usually first select to use radius and press Set Auth Type, then wait for 30 to 60 second and put in the destination port, ip address and key before presing the set parameters. (It seems that the APPO gets busy with something when you press the Set Auth Type button so you will have to wait a bit before you can save the rest of the settings? Best Regards Oleb -----Original Message----- From: Marcin [mailto:[EMAIL PROTECTED] Sent: 30. oktober 2003 12:19 To: GRUPA SMARTBRIDGE Subject: [smartBridges] Radius auth. dosn't work on1.4j.9? Hi, Is there anybody who has radius auth. running on firmware 1.4j.9? As I know it works only on firmware 1.4j.5. KiF ----------ANNOUNCEMENT---------- Don't forget to register for WISPCON IV http://www.wispcon.info/us/wispcon-iv/wispcon-iv.htm The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org ** This message does not contain any viruses - scanned by Elektron and Webconnect virusscanner ** ** This message does not contain any viruses - scanned by Elektron and Webconnect virusscanner ** ----------ANNOUNCEMENT---------- Don't forget to register for WISPCON IV http://www.wispcon.info/us/wispcon-iv/wispcon-iv.htm The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org
