On Sep 5, 2014 8:27 PM, "RYAN M. vAN GINNEKEN via smartos-discuss" <
[email protected]> wrote:
>
> I have some networking questions directly below is a bit of a network
diagram not sure if it is completely accurate or even correct other infos
follow.
>
> INET >>>> ibg0 >> GZ >> admin_nic >> IPF/NAT >> gw0 >> switch0 >> GZ >>>>
zones and KVMs
>
> Anyways i would like to add an Internal nic or vnic to the GZ with IP
address 172.16.0.200 so that i can setup NFS, FIFO, etc using an internal
ip instead of the external one, is the internal NIC TAG listed below from
my /usbkey/config file going to work for me or is there a better more
correct way.  Also can i use a virtual MAC address, or a real MAC address
from one of my unplugged NICS? or can i just ommit to MAC and let SmartOS
do some magic and create or not need one?
>
> Here is part of my /usbkey/config please see the internal_nic section
>
> admin_nic=0:25:90:e9:c:4
> admin_ip=204.244.122.132
> admin_netmask=255.255.255.224
> admin_network=...
> admin_gateway=204.244.122.129
>
> etherstub="switch0"
>
> #Internal nic connects GZ to internal network?
> internal_nic= ???????????? use real mac of one of my unplugged NICs or
use virtual MAC or can i skip MAC all together ?????????
> internal0_ip=172.16.0.200
> internal0_netmask=255.255.255.0
> internal0_gateway=172.16.0.1
>
> Here is a bit more about the network, and i have to say thanks to lots of
folks on the IRC that have helped me get this far
>
> I have this in /opt/custom/bin/net-setup
>
> ## setup gw0
>   4 if [ `dladm show-vnic | grep gw0 | wc -l` -ne 1 ]; then
>   5   /usr/sbin/dladm create-vnic -m 2:8:20:bc:d5:5f -l switch0 gw0
>   6   /usr/sbin/ipadm create-addr -T static -a 172.16.0.1/24 gw0/v4
>   7 fi
>   8
>   9 ## setup ip forwarding
>  10 /usr/sbin/routeadm -u -e ipv4-forwarding
>  11 /usr/sbin/routeadm -u -e ipv6-forwarding
>  12 A bunch of IPF/NAT rules to make things happen
>
> Some more hopefully helpful infos
>
> dladm show-phys
> LINK         MEDIA                STATE      SPEED  DUPLEX    DEVICE
> igb0         Ethernet             up         1000   full      igb0
> igb1         Ethernet             up         1000   full      igb1
> igb2         Ethernet             down       0      half      igb2
> igb3         Ethernet             down       0      half      igb3
>
>
> ifconfig -a
> lo0: flags=2001000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv4,VIRTUAL> mtu
8232
index
1
>         inet 127.0.0.1 netmask ff000000
> igb0: flags=1100843<UP,BROADCAST,RUNNING,MULTICAST,ROUTER,IPv4> mtu 1500
index 2
>         inet 204.244.122.132 netmask ffffffe0 broadcast 204.244.122.159
>         ether 0:25:90:e9:c:4
> dell0: flags=1100843<UP,BROADCAST,RUNNING,MULTICAST,ROUTER,IPv4> mtu 1500
index
3
>         inet 192.168.1.10 netmask ffffff00 broadcast 192.168.1.255
>         ether 2:8:20:d9:4e:6a
> gw0: flags=1100843<UP,BROADCAST,RUNNING,MULTICAST,ROUTER,IPv4> mtu 9000
index 4
>         inet 172.16.0.1 netmask ffffff00 broadcast 172.16.0.255
>         ether 2:8:20:bc:d5:5f
> lo0: flags=2002000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv6,VIRTUAL> mtu
8252
index
1
>         inet6 ::1/128
> gw0: flags=20002100840<RUNNING,MULTICAST,ROUTER,IPv6> mtu 9000 index 4
>         inet6 ::/0
>         ether 2:8:20:bc:d5:5f
>
>  netstat -rn -f inet
>
> Routing Table: IPv4
>   Destination           Gateway           Flags  Ref     Use     Interface
> -------------------- -------------------- ----- ----- ---------- ---------
> default              204.244.122.129      UG        7   10846355 igb0
> 127.0.0.1            127.0.0.1            UH        4     696826 lo0
> 172.16.0.0           172.16.0.1           U        10   11739732 gw0
> 192.168.1.0          192.168.1.10         U         2          0 dell0
> 204.244.122.128      204.244.122.132      U         7     442026 igb0
>

Hello,

I only wish to understand your network so unfortunately do not have any
advice.

You have global zone directly connected to the internet? That is, your
admin IP is addressable from the internet. If I am correct may I ask why?
Or rather why not use SmartOS's built-in external_nic for external access
and firewall from there?

Regards,
Usama

>
> Computer King                   CaN-Mail                    Surveillance
King
> http://computerking.ca     http://canmail.org
http://surveillanceking.net
>
> Surveillance - Sales Service - Hosting Backup
> Internet Based Surveillance Systems
> Custom Service Pac kages
> Secure IMAP Email - Automated Remote Backups - Photo Blogs - Online ERP
and Accounting Packages
>
> smartos-discuss | Archives | Modify Your Subscription



-------------------------------------------
smartos-discuss
Archives: https://www.listbox.com/member/archive/184463/=now
RSS Feed: https://www.listbox.com/member/archive/rss/184463/25769125-55cfbc00
Modify Your Subscription: 
https://www.listbox.com/member/?member_id=25769125&id_secret=25769125-7688e9fb
Powered by Listbox: http://www.listbox.com

Reply via email to