Hi,
I just installed soap2.2 on WebLogic 5.1, when I check the
correctness
of server installation,
http://localhost:7001/soap/servlet/rpcrouter OK, the message
occurs
just like the document says. however,
http://localhost:7001/soap/servlet/messagerouter not correct, the
information occurs:
Error 404--Not Found
From RFC 2068 Hypertext Transfer Protocol -- HTTP/1.1:
10.4.5 404 Not Found
The server has not found anything matching the Request-URI. No
indication is given of whether the condition is temporary or
permanent.
If the server does not wish to make this information available
to
the client, the status code 403 (Forbidden) can be used
instead. The
410 (Gone) status code
SHOULD be used if the server knows, through some internally
configurable mechanism, that an old resource is permanently
unavailable and has no forwarding
address.
Also, when I use list, deploy and un-deploy in admin page, same
error
occurs.
Please kindly tell me the possible reason.
I am new to soap and want to implement soap in my research
prototype. I
want to command soap in a quite short time.
Thanks
Michael.
--
----------------------------------------------------------------------------
Michael Q.Z. Sheng Office: 504 K-17
Kensington
Database Group Telephone: 61 2 9385
7998
School of Computer Sci. & Eng. Facsimile: 61 2 9385
5533
University of New South Wales
Email:[EMAIL PROTECTED]
Sydney, NSW 2052, Australia
Webpage:www.cse.unsw.edu.au/~qsheng
----------------------------------------------------------------------------
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, email: [EMAIL PROTECTED]
