At 12:23 AM 9/28/99 -0400, Jim Carlton wrote: >As per the Logic HL, can anyone give me a hint as to how the pushrod is >attached to the control surfaces of the rudder and elevator and a source >for materials to achieve this? I believe a small section of braided >spectra line is used as a sleeve , installed over the pushrod end, CA'd >and then snapped to make a knuckle or hinge? Am I on the right track? TIA. This is a very common building question. Sal should post the Logic directions on the net. I could also get permission and do it myself too. Anyway, you are right on track Jim. The CF rod is first sharpened like a pencil. Slide about 1" length of spectra onto the rod, pull the length of spectra tight and CA both ends. The length of rod that sticks out will depend on how long the "control horn" or linkage should be. Snap the CF rod in the middle and flex. Push sharpened CF rod into control surface and CA. Good luck Steve Meyer http://www.mcs.net/~stmeyer/ [EMAIL PROTECTED] S.O.A.R. in Gurnee, IL S.O.A.R. Web Page http://www.mcs.net/~stmeyer/SOAR/ RCSE-List facilities provided by Model Airplane News. Send "subscribe" and "unsubscribe" requests to [EMAIL PROTECTED]

