John;

You should try our Stamov booms they are produced to use as model tail booms
and they are very light and very stiff.  By far the best combination I have
seen.  The standard booms are 14 to 15 grams each .6" to .3" taper over 36
inches.  We have a few 11 gram booms at the same dimensions, these booms are
not as strong or stiff, that is the trade off when they get that light.

They are listed on our web site www.cstsales.com or you can call our toll
free number and get the details. 1-800-338-1278

Thanks
Matt Gewain
The Composites Store


-----Original Message-----
From: Kappus, John [mailto:[EMAIL PROTECTED]]
Sent: Tuesday, January 18, 2000 6:02 PM
To: '[EMAIL PROTECTED]'
Subject: [RCSE] Avia tail booms


I build a 7oz 60" HLG with a mid length boom of the Avia G-force using the
BIG end of the taper.  This results in a light fuse of less than .75 oz.
However, I believe that this is not quite stiff enough for a hard throw at
launch.  At launch, an odd thing happens with this boom.  Even with a bit of
launch UP preset, the throw goes straight out for farther than normal before
pitching up when the speed and loads go down.  With a stiffer boom (like a
Shark kite spar at +.25oz more), the up response is more immediate.  I'm
still searching for the perfect combination including molding a little more
carbon down the boom during fuse mfg.


------------------------------

Tom Broeski writes:
>http://www.intothewind.com

Their Avia wrapped tapered carbon tubes are perfect for HLG tailbooms.
At about $8 these aren't cheap, but they are almost half the weight of
pultruded tubes for a given bending stiffness.  They are also much
better
in torsion.

They have three weight - stiffness grades:

 Skinny Ultralight     7.7g  ,  stiffness =1.8
 Skinny Super UL    11.7g  ,  stiffness =3.2
 G-force Ultralight  13.0g  ,  stiffness=4.9

The weights are for the shorter 32.5" lengths.
The stiffness numbers are relative.

The two Skinnys have the same ID's but different wall thicknesses.
The G-force has a larger ID and hence a much better stiffness/weight
ratio.

The big end of the Skinny Ultralight is perfect for 3-4oz , 30"-40"
gliders.
For a 60" glider the small end of the G-force is probably just right.

- Mark Drela
RCSE-List facilities provided by Model Airplane News.  Send "subscribe" and
"unsubscribe" requests to [EMAIL PROTECTED]

RCSE-List facilities provided by Model Airplane News.  Send "subscribe" and 
"unsubscribe" requests to [EMAIL PROTECTED]

Reply via email to