Hi Cliff,
your servos should work fine if you change plugs.  The only thing is make
sure you get the red (B+) in the center of the plug and the middle black wire (B-) to
the edge of the plug. the other black wire is as you said, the signal or information 
lead
and goes to the other edge of the new plug.
Thermals,
Art

Cliff Schwinger wrote:

> I have a used CR Climax that I purchased from someone through the
> internet.  It came with two Cirrus CS-20 BB sub-micro servos with
> Airtonics connectors.  I would like to clip the Airtronics connector and
> splice on a Hitech connector.  The servo leads have one red wire (an end
> wire) and two black wires (the center wire and the  other end wire)  The
> wire color chart on the back of the package of one of my servo extension
> wires indicates that the for Airtronics connectors, the red wire is the
> positive lead, the center wire is the negative lead and the other end
> wire is the signal lead.  The same chart indicates that for Hitech
> connectors, red is positive, black is negative, and yellow is the
> signal.
>
> Is it safe to clip the leads and splice on my Hitech extension using the
> wire color chart as a guide?
>
> Thanks for any advice anyone might have regarding this matter.
>
> Cliff
>
> (I have really high expectations regarding the anticipated performance
> of my CR Climax. It has a small sticker on the wing indicating that it
> was flown in the 1999 IHLGF!  To me, that�s like buying a used car and
> then finding out that it was raced in the Daytona 500!)
> RCSE-List facilities provided by Model Airplane News.  Send "subscribe" and 
>"unsubscribe" requests to [EMAIL PROTECTED]



RCSE-List facilities provided by Model Airplane News.  Send "subscribe" and 
"unsubscribe" requests to [EMAIL PROTECTED]

Reply via email to