There were some bad xtals produced, so you might want to check that also.
JR are compatible if you don't have other Bergs.
Tom Robert Massmann wrote: I have a (4) servoed Wizard D light with a Berg receiver and I am using a Vision with (8) model memory. I have had problems after recharge the batteries and applying power to the receiver with the transmitter already turned on, the servos go nuts and to full travel in opposite directions. The battery pack that I made uses (4) cells from a Radio Shack Nimh 9 volt pack. When I remove any (2) servos, the remaining (2) work normally. The also seems to work fine using plain nicad batteries. I haven't tried a (3) Nimh pack yet, but that will be the next thing I try. I haven't looked at the system current draw to see if there might be causing problem. Any suggestion would be appreciated. --
T&G Exhibits (Exhibit and Prototype Design)
|
- RE: [RCSE] Berg Reciever and Nimh battery Problem. Tom Broeski
- RE: [RCSE] Berg Reciever and Nimh battery Problem. Werner, Jason
- Re: [RCSE] Berg Reciever and Nimh battery Problem. Ralph Weaver
- Re: [RCSE] Berg Reciever and Nimh battery Problem. Y.K.Chan