To cut a given piece of foam with the desired ease, a wire needs to be at a
certain temp.  At that temp it has a certain resistance.  To get it to that
temp, a voltage must be applied that provides enough current to heat the
wire.

Use a different type of wire and it still needs to be at the same temp to
cut the foam the same way.  At that temp it may have a different resistance
than the first type of wire.  The voltage required will be different with a
different resistance but it should still work out to the same power.  No?

Depending on your available power supply, it might be desirable to operate
at a higher or lower voltage, but I haven't heard any plausable argument
that one type of wire can cut at a lower power.

It does seem reasonable that a _thinner_ wire might cut at lower power but
that would be independent of the type of wire.  It also seems reasonable
that some material might be stronger and thereby permit thinner wire to be
used.  Is this the case?  Can some wire types be used in thinner gauges to
reduce power and kerf?

Has anyone compiled data on wire types and gauges?

Rick,

> Most wire has a positive temperature coefficient of resistance which means
> the resistance increases with temperature. As an example, the tungsten
> filament in an incandescent lamp has a hot working resistance about 20
times
> greater than its room temperature resistance. The transformer ratings may
be
> constant but that just refers to the upper safe limit. Most foam cutting
> power supplies have some form of voltage adjustment which, with the heated
> wire resistance, produces a current. If properly designed and used, the
> actual voltage, current and power at any particular adjustment are at or
> under the rated values for the components.
> Regards, Ollie

RCSE-List facilities provided by Model Airplane News.  Send "subscribe" and 
"unsubscribe" requests to [EMAIL PROTECTED]

Reply via email to