At 10:58 PM 5/2/00 -0400, Eric Sanders wrote: >Yep, I caught it... Zagi fever. >The problem is I can't seem to find the correct setup for the Vision. I >tried both an Airtronics 4channel and RCD 5 channel (four channels >available). The closest I came was setting the Vision for 2A/1F<>E R, >putting it into mode B, and mixing the elevator with ailerons. This got it >to the point that I had elevon and aileron working but on the wrong sticks! >The speed control was on the right stick and ailerons/elevons on the left >stick. >What am I missing here? Could someone email the correct setup for this. If >you could cc to [EMAIL PROTECTED] I would greatly appreciate it. > >TIA >Regards, >Eric Sanders >www.compufoil.com Eric, I didn't see anyone else respond to your post, so here's the solution. I am assuming that you have the most recent software (F3B V3.01A) in your Vision. First, move to the Config column and select the 2A/2F<>E R wing type. Second, scroll down and select the appropriate receiver (A type PPM 4) if you use the Airtronics 4 channel receiver mentioned above (left elevon will plug into channel #1 and right elevon into channel #3. Third, in the Main column, select "Yes" for Alter Mode, "No" for Mode B. Fourth, in the Config column, scroll down to the servo direction and make any appropriate changes (left elevon will be the first slot and the right elevon will be the fourth slot). Fifth, verify that the directions and throws are correct. Set the throws for the aileron function in the Surface menu as you would with traditional ailerons. If the elevator travel needs further adjustment than available in the Surface menu, move to the Mixer column and scroll down to Elev->LAIL & Elev->RAIL and increase these values a bit more. Make sure that the values match each other to avoid elevator unbalance. Sixth, go fly! Tom Hoopes - [EMAIL PROTECTED] CD - Soar Utah 2000 http://www.silentflyer.org RCSE-List facilities provided by Model Airplane News. Send "subscribe" and "unsubscribe" requests to [EMAIL PROTECTED]