If it is an AT power supply, you can make it work by putting a 5 Ohm Power
resistor rated for at least 10 Watts between +5V and GND.  On an ATX power
supply, in addition to that, you should put a switch between PWR_ON# and
GND.  PWR_ON# is the 4th pin from the left if you looked at the main
connector with the latching hook at the top.  GND is the 3rd, 5th, 6th, and
7th pins on the top row.  This must be kept closed for the P/S to work
without a motherboard.

The 5 Ohm resistor puts a 1 Amp load on the 5V output of the power supply
which must be used so that it can internally regulate its voltages.

-----Original Message-----
From: Erik Wikran [mailto:[EMAIL PROTECTED]]
Sent: Friday, August 18, 2000 1:35 PM
To: Soaring-Digest
Subject: [RCSE] Power supply (PC)


Is it possible to use a computer power supply as a suply for a charger?
I have tried but I have to have a motherboard connected to it for it to
run. Is it possible to make some modifications to the supply so it can
run without the motherboards?
-- 
Regards
Erik Wikran
Tromso, Norway
---------------
RCSE-List facilities provided by Model Airplane News.  Send "subscribe" and
"unsubscribe" requests to [EMAIL PROTECTED]
RCSE-List facilities provided by Model Airplane News.  Send "subscribe" and 
"unsubscribe" requests to [EMAIL PROTECTED]

Reply via email to