>
>Similar question: I'm just about finished building a vac system and am
>thinking about bagging my first wing. How do I bag a triple taper (Shumann)
>wing? The surface has got to really look bad if I fiberglass wrap every
>transition like Olly was talking about after the bagging. OTOH, aligning
>all those seperate sections and beds perfectly during the bagging sounds
>like a nightmare to me, though much more appealing structurally. How's it
>done?
>
>Tony Rogers
Putting the beds and cores together is really easier than you imagine. First
get some of that thin, clear packing tape. Tape the bottom core beds
togrther in alignment by wrapping the tape all the way around, starting at
the leading edge. Then cover the joint temporarily with waxed paper and glue
the cores in alignment with form compatible CA. Be careful to use it
sparingly so that it stays away from the top and bottom surface of the foam.
Alternately you can glue the core panels together with 3M77 but you have to
mask the cores so that it only goes on the ends. The glued together cores
are quite fragile and must be handled with care. After the cores are joined
the top core beds can be taped together as were the bottom core beds. It is
best if the cores are cut with the joining in mind because success depends
on clean square cuts at the ends of the blanks and, blanks of uniform
thickness with smooth surfaces.
Regards, Ollie
RCSE-List facilities provided by Model Airplane News. Send "subscribe" and
"unsubscribe" requests to [EMAIL PROTECTED]