I would do the same as Doug in the same situation.
That reminds me of a wing repair I made with on balsa wing. While at repair
planning, I thought if I don't do anything else, the delam may happen in
again should the same stress repeat in the future. I decided it need some
"pull down" component against any stressed rippling, which lends itself to
delam. I used a procedure what Doug says and finish the repair. {The
follwoing method will need some creativity for repair along wing rod
section) Then I drill pin holes through the wing panel in line along the
possible ripple segment. GF threads or sticks of equal hole size will put
through the holes intended to "fixed" the dimension (thickness) of wing
top/bottom lam against possible stressed ripples. I finished it with epoxy
at the stick-skin junction. (expsy wetting at the middle section of GF
threads is not necessary). For balsa skin, I have tried (bamboo) tooth picks
pointed ends. It is sharp and strong enough to penetrate the whole pannel
(not at spar and rod section). I finish it with CA glue at the skin and
stick junction. Hope that helps.
YK Chan
Seattle
> From: Doug Reel <[EMAIL PROTECTED]>
> Organization: M.P.A.
> Date: Mon, 04 Sep 2000 13:50:53 -0700
> To: Soaring Exchange <[EMAIL PROTECTED]>
> Subject: Re: [RCSE] Delaminaton of wing(composite) How do I fix it?
>
> Delaminations are rather easy to fix. I will briefly touch upon how I go about
> fixing them. First of all you want a good epoxy resin
> with at least 30-45 minutes working time. I have had great results with West
> Systems resin and the 209 hardener. The resin needs to
> be a low viscosity resin and even then I often thin it with rubbing alcohol so
> that it will flow better into the wing. Once I have
> mixed the resin I load it into a syringe and inject it into the delamed area.
> If the delam is located at either the LE or TE, that
> is where I insert the syringe. If it is in the middle of the wing I will drill
> a small hole in the skin and insert the syringe
> through there. I try and press on the wing to 'open up' the delam areas and
> allow the resin to spread throughout the area. When
> satisfied with injecting of the resin, place the wings in their beds and put
> weights on them to hold everything down. If you have a
> bagger then put the wing in the bag and then place in the beds.
>
> Doug Reel
> Pacific Palisades, CA
>
>
>> I have some delamination of my wing. There are spots that are as large as
>> 1x3" and as little as .5x.5". What are some ways that I can fix this up. I
>> have not painted the wing yet, just primed.
>> Stan
>>
>> RCSE-List facilities provided by Model Airplane News. Send "subscribe" and
>> "unsubscribe" requests to [EMAIL PROTECTED]
>
> RCSE-List facilities provided by Model Airplane News. Send "subscribe" and
> "unsubscribe" requests to [EMAIL PROTECTED]
RCSE-List facilities provided by Model Airplane News. Send "subscribe" and
"unsubscribe" requests to [EMAIL PROTECTED]