Stefan,

The usual sequence is to spray 3M77 on the EPP surface that you are 
about to cover.  Don't spray the other surfaces until you are ready 
to cover.  If you spray everything in the beginning, everything on 
your workbench will end up stuck to the 3M77 coated surfaces.  After 
spraying that one surface, put on the strapping tape.  Sanding the 
strapping tape is optional, but it does help the adherence of the 
covering.  After putting on the strapping tape (and possibly sanding 
it) spray once again with 3M77.  You only need to spray the tape, but 
you will inevitably end up spraying most of the surface.  Then apply 
the Ultracote with an iron.

Repeat with the other surfaces to be covered.  While doing so, try 
not to get too much dust and junk in the 3M77 covered surfaces.  When 
you are done with the covering on all surfaces, wipe off all of the 
3M77 overspray on the Ultracote using Goo Gone.  Finally, take out 
the remaining wrinkles and shrink the covering with a heat gun.

The 3M77 softens with heat so that there is no problem with shrinking 
the covering.  In fact, if you ever need to remove the Ultracote or 
strapping tape, use a heat gun to soften the 3M77 and you can readily 
peel off the Ultracote or tape.  In the same vein, be careful when 
using the heat gun where the Ultracote has been stretched around 
curves or where the Ultracote is overlapped.

Dick

====================

>I still have a Zage EPP lying around, that I'll start building after my
>Highlander, but since it are both foamies:
>
>>I always cover my foamies with Oracover/Ultracover...
>>Sand the strapping tape good and put on a good coat of 3M 77 I use about
>3/4 heat setting >on the iron.  Tack down the top and bottom completly
>before you go for the smooth finish.
>>lay the wing in the beds and iron/heat gun until it's nice and tight...
>
>Do you put a coat of 3M77 only on the strapping tape, or only at the places
>you'll tack it down, or everywhere ? If there's 3M77 everywhere, it seems
>hard to stretch to me, but I've never tried it (I used the _red_ tape that
>came with my Zagi 400 on that one, didn't know then it could be done with
>Oracover ..)
>
>Stefan.
>
-- 
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Dr. Richard C. Williamson            Phone:  781-981-7857
Room C-317                           FAX:    781-981-0122
Lincoln Laboratory                   Email: [EMAIL PROTECTED]
Massachusetts Institute of Technology
244 Wood Street
Lexington, MA 02420-9108
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 
RCSE-List facilities provided by Model Airplane News.  Send "subscribe" and 
"unsubscribe" requests to [EMAIL PROTECTED]

Reply via email to