Greetings!

About a month ago there was a bit of chatter on this list
regarding the Eclipse, a molded plane designed for F3J.  The
general comment was that it is a great flying plane but
don't fly it slow.

I have one I'm getting ready for next season and these
comments started me wondering.  I've built and flown planes,
making some assumptions about things, assumptions that were
later demonstrated as being totally wrong.  Problems in slow
flight might be do to any number of things.  I did some
measurements to check over my wing.  I used a very flat
surface, measured to the nearest 1/64 inch and repeated all
measurements until I was satisfied I was doing everything
correctly.  

For those not familiar with this plane, it has a flat, large
center section to the wing, with two plug in wing tips. 
There is a picture of it at:
http://www.nesail.com/eclipse.html

To do the measurements I used 1/4" aluminum blocks under
middle of the center section at leading and trailing edges
and then another block under the leading edge at joint.  By
definition (my method) the leading edge was held straight. 
I found that my plane has a wash-in of 1/8 inch full span. 
I'm no aerodynamicist, but I think this would lead to tip
stall for the inboard wing on a turn.  I've know some planes
to have wash-in to a similar joint and then wash-out to the
wing tip. This is not the case here.  The trailing edge is
always lower relative to the root chord.  Further
measurements showed that the left wing tip was about 1/2
inch higher off the table top than the right, i.e. the
dihedral angle set by the supplied, angled carbon wing rods
are not the same.  I would think this would influence
stability in right turns vs left turns.

All this has me wondering.  I have a lots of questions.  Any
and all comments are welcome.

Specific questions:

1.  Would other Eclipse owners check their planes and see if
this is unique to my particular plane or is it a part of the
Eclipse tradition?

2.  Would other folks with molded planes check their wings
and see if this is a rare occurrence or is this the way
these planes come to us.

General questions:

3.  Is there any reason why full-span wash-in would be a
desirable design feature of a plane designed for F3J/TD?  

4.  When you get a bagged or molded plane.  After the Ooooos
and Aaaahhhss, do you ever actually measure things like
wash-in/wash-out and dihedral angles to make sure all is as
it should be?

5.  Does anyone know if manufactures check all measurements
to make sure what they think they are selling is what they
in fact are shipping??

I'm not overly concerned.  Judicious application of a bit of
warmth and load will remove wash-in and a bit of filing and
such will correct for the dihedral angle discrepancy.  To
anyone who as actually done this to a moldy, any all
comments and suggestions are welcome.  

What does have me wondering if planes actually come to us
with a wide range of built-in factors such as wash-in or
unbalanced wash-out, etc. and this is a reason why some
people swear by a particular plane and others swear at the
same design but a different actual plane.  It also leads me
to think that some folks routinely check and correct for
these discrepancies and their planes simply fly better.  We
meet these folks on weekends.

Any and all comments welcome.

Bill
-- 
There is a very fine line between "hobby" and "mental
illness." 
                                            Dave Barry
Bill Johns
Pullman, WA
RCSE-List facilities provided by Model Airplane News.  Send "subscribe" and 
"unsubscribe" requests to [EMAIL PROTECTED]

Reply via email to