Mark,
I was going to make an Apogee, but the sanding scared me away. I built
a Terminator instead, but with a built up AG03 and a conventional tail.
You're welcome to take a look at it - I just posted the pic today:
http://home.adelphia.net/~sliderule and follow the link to the "hangar". It
was 10-1/2 oz all up weight with a 250 mAH battery, HS55 servos and a 555
receiver. The fuse is getting heavy from repairs, but the wing is still
intact. The D-tube wing was just over 4 oz with Monokote covering.
I _AM_ going to make an Apogee, some day.
Quick question: what percentage of MAC do you recommend for the CG on
the AG03 foil? The Apogee plans give the location, but it looks like
percent of root chord and not MAC.
Thank you and The Charles River RC'ers for your club's web site and its
contents. http://www.charlesriverrc.org
Tom Koszuta
Buffalo, NY
----- Original Message -----
From: "Mark Drela" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Thursday, May 31, 2001 3:20 AM
Subject: Re: [RCSE] Apogee
>
> >Before going ahead and committing myself , I'm trying to find out
> >about more about the flying behavior. particularly the 36" as opposed
> >to the 40".
>
> The 36" is a bit more maneuverable in tiny thermals,
> and is better suited for turbulent air (again because
> of its maneuverability). The 40" has a bit more L/D
> and a bit lower dead-air sink rate.
>
> The 40" is easier to get down to the right loading.
> If you're using a 555 and 110 mAh NiCd cells then
> I'd go for the 40". If you're using a lighter RX
> (like the Extreme) and the "50" size NiMH's, then
> I'd go for the 36". Definitely use HS-50's, since
> they run OK on 3 cells.
>
> I would make the solid wing if at all possible.
> It seems to be much more durable and relatively
> immune to warping.
>
> - Mark
>
> RCSE-List facilities provided by Model Airplane News. Send "subscribe"
and "unsubscribe" requests to [EMAIL PROTECTED]
RCSE-List facilities provided by Model Airplane News. Send "subscribe" and
"unsubscribe" requests to [EMAIL PROTECTED]