> >.. The supprt bearing does have 
> >to be hard and strong though because lateral and vertical forces
> >are exerted from the pocket friction and geometry of the RADS. 
> >This makes the torque shaft lever against the support bearing.
> 
> .... I don't see why the support bearing has to be 
> "hard and strong", when it also has to have slop. 

Maybe it's unwaranted, but my concern is over lateral
torque rod movement resulting from friction in the 
pocket in ailerons and friction caused verical and 
horizontal torque rod motion in the flaps.
The support bearing might be termed better as the
"torque rod deflection limiter". The term "hard and strong" 
is relative. In this case relative to insulation foam.
I imagine a few flakes of foam getting knocked of the into the 
pocket which enhances friction and gouges out more foam.
The additional foam jams up the slot.Then the RADS connector is 
flexed more and then....

It seems that a 90 degree aileron RADS could function well
with a little verical "slop" and none lateral.
The 45 degree drive flap RADS could work well with
no vertical slop and some small lateral amount.

So to limit the possible torque rod flex the deflection
limiting sloppy bearing should be large enough to 
allow non binding kinematics but no bigger. This insures
that the total torque rod flex is minimized which 
is nicer for the servo and RADS connector.

John Hazel



Find the best deals on the web at AltaVista Shopping!
http://www.shopping.altavista.com
RCSE-List facilities provided by Model Airplane News.  Send "subscribe" and 
"unsubscribe" requests to [EMAIL PROTECTED]

Reply via email to