RDS belongs to the family of Limited Displacement Universal Joint, and I
call it a "sine coupler" after its transfer function, "sine".  RDS is
developed by my friend, Harley.

The operating principle assumes an ideal torsion rod with an ideal bend
point that lies along the hinge line (Ideal torsion has zero elasticity and
zero diameter, an ideal bend has zero bending radius).  This is an
important concept to be understood so that interference fit can be avoided
during implementation and installation.

* Any practical bend follows a bending radius. This constitute a spurious
displacement around the bend that can interfere with the pocket front. If
not cleared, we may risk pried open or cracked pockets. One solution is to
back out the pocket and clear the spurious space, such that at any torsion
rod displacement angle, the pocket front will always be clear of the curved
part of the rod end section.

* In case of offset hinge line (with respect to the bend point), apply the
same
rule above. And, identify the imaginary ideal bend point and align it at
the vertical plane extending along the hinge line.

* The more we allow the hinge line offset to the imaginary bend point, the
more it is the set back required of pocket front back away from the bend.
Soon the rod end section may run out of the pocket or may begin prying the
pocket under load and risk cracking it. One solution is to lengthen the end
section rod and a deeper pocket. This leads to a rule of thumb, make a
deepest pocket and longest end section as practically feasible.

* By the way, a good quality hinge realization is important bring out the
essence of a RDS system. Consider top-bottom hinge tape, or X hinge.
(X represents short sections of tape run alternatively in "/" and "\" along
the
hinge line, going from bottom flap to wing top and top flap to wing
bottom).

I hope that meets Harley's approval.

YK


RCSE-List facilities provided by Model Airplane News.  Send "subscribe" and 
"unsubscribe" requests to [EMAIL PROTECTED]

Reply via email to