David,
It's real easy. Go to the launch/camber menu. Turn the trim to "on" or
"active". Set your camber to where you want it with the right hand slider.
Turn the trim to locked or off or inactive (I'm doing this without a radio
in front of me). Next go to the launch/flap menu and adjust the flaps until
they are equal to the ailerons. If these steps do not give all the camber
you need then you need to get out of the launch menu and page down to the
"camber" menu (this is a seperate menu) Go into camber and increase the
individual values for each wing surface. Go back to the launch menu and
repeat above.
The final step is to go to EPA. The last entry under EPA is CM or CB.This
adjusts the amount of throw of the side lever. You will want this for
thermal mode.
Good luck and feel free to call if you need further help.
Jim McCarthy
847-487-9070
----- Original Message -----
From: "David J. Schat" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Tuesday, August 14, 2001 7:06 PM
Subject: [RCSE] Stylus help
> I need some help with the programming of the flaps/ailerons on launch
mode.
> I've a headache from trying to figure it out and now need a brewskie. I
can
> see that it has something to do with the slider on the right side of the
> Xmitter but can't get the sequence right or something. (serves me right
for
> poaching a setup from someone else and not learning it myself).
>
> I have some trailing edge camber dialed in but would like a little
more....
> can't seem to figure it out, dammit.
>
> -Spud Boy
>
> Wit is educated insolence. (Aristotle)
>
>
>
>
>
> RCSE-List facilities provided by Model Airplane News. Send "subscribe"
and "unsubscribe" requests to [EMAIL PROTECTED]
>
RCSE-List facilities provided by Model Airplane News. Send "subscribe" and
"unsubscribe" requests to [EMAIL PROTECTED]
