Bill You have some small input to the servo from one of the mixers feeding that servo. It may or may not show in the servo travel or check if there is an input that is in there for the different flight modes. If not just center the servo as normal and then in the servo travel for one of the mixer inputs.
On Mon, 13 May 2002 20:54:25 -0700 Bill Johns <[EMAIL PROTECTED]> writes: > Why, when centering servos with the Profi 3030, you can put the servo > dead > on in centering mode, then when you switch out of centering mode, > the > surface jumps a bit. In order to get the surface at the desired > position > you have to "center" it off a bit so when it jumps it goes where you > want > it to. Most frustrating. > > Anyone?? > > Bill > > -- > Experience is something you don't get until just after you need it. > > Bill Johns > Pullman, WA > > RCSE-List facilities provided by Model Airplane News. Send > "subscribe" and "unsubscribe" requests to [EMAIL PROTECTED] Fred McClung Albuquerque NM RCSE-List facilities provided by Model Airplane News. Send "subscribe" and "unsubscribe" requests to [EMAIL PROTECTED]
