"If there is too small a charge current there will not be a "end of 
charge curve" and the computer won't know when to stop..."

That explains what I have observed.  Regis

--- In [EMAIL PROTECTED], George Joy <[EMAIL PROTECTED]> wrote:
> Tom and all,
>       You are correct, and you should NOT start the charge over to 
fill a 
> larger NiMH cell. You can do this with any large NiCd cell.
>       Our charge circuit uses the "end of charge" voltage curve to 
> determine when the pack will reach peak. A NiCd cell will develop 
and "end 
> of charge" curve at almost any charge current, but a NiMH cell 
needs a 
> minimum amount of current, depending on size, to develop that 
voltage 
> curve. If there is too small a charge current there will not be 
a "end of 
> charge curve" and the computer won't know when to stop, so there 
goes the 
> pack,poof :-).
>       We warrantee the charger will SAFELY charge NiMH cells up to 
1200 mAh 
> for the Pro Series and up to 3000 mAh for the upgraded version.
>       Also you are correct about the switch, it will not change the 
charge 
> current.
> Smooth Landings
>     George
> 
> At 05:45 PM 7/28/2003 -0700, Tom Watson wrote:
> >Hold on there...the Pro series won't handle NiMH RX packs above 
1200 MAh
> >(check the manual on this - I'm pretty sure about the size), 
unless the
> >charge cycle is started over once complete.  Setting the selector 
switch
> >doesn't alter the charge current.  Following is a direct quote 
from George
> >Joy from a while back:
> >
> >"There is a misconception about the switch on the Pro Series 
charger, it
> >does not change the charge current, it only sets the "Maintenance 
Mode"
> >charge profile, and an emergency shutdown mode.  You cannot "slow" 
charge a
> >pack by putting the switch in the lowest position. If you try this 
with a
> >pack above 500 mAh it will never get it full, the emergency 
shutdown mode
> >will terminate the charge before it is full."
> >
> >The Pro series must be modified to handle big packs and the Sirius 
guys can
> >provide this service.
> >
> >Tom
> >
> >
> >----- Original Message -----
> >From: "Andrew E. Mileski" <[EMAIL PROTECTED]>
> >To: <[EMAIL PROTECTED]>
> >Sent: Monday, July 28, 2003 5:00 PM
> >Subject: Re: [RCSE] Charger Question
> >
> >
> > > Pat McCleave wrote:
> > >
> > > > I just received a new 2000ma Nimh Battery with my new NYX F3F 
and I was
> > > > wondering if I will be able to charge it with my Sirius Pro 
Charger.
> > >
> > > Set it to 200 mA and it will charge overnight.  Most Ni-MH can 
handle
> > > a C rate (2000 mA) for a 1 hour charge, and if in a real hurray 
some
> > > can deal with 2C or more (check the cell specs).
> > >
> >
> >RCSE-List facilities provided by Model Airplane News.  
Send "subscribe" 
> >and "unsubscribe" requests to [EMAIL PROTECTED]  Please note 
> >that subscribe and unsubscribe messages must be sent in text only 
format 
> >with MIME turned off.
> 
> 
> 
> RCSE-List facilities provided by Model Airplane News.  
Send "subscribe" and "unsubscribe" requests to [EMAIL PROTECTED]  
Please note that subscribe and unsubscribe messages must be sent in 
text only format with MIME turned off.

RCSE-List facilities provided by Model Airplane News.  Send "subscribe" and 
"unsubscribe" requests to [EMAIL PROTECTED]  Please note that subscribe and 
unsubscribe messages must be sent in text only format with MIME turned off.

Reply via email to