UTP -- Unshielded Twisted Pair
STP -- Shielded Twisted Pair

STP would be serious overkill for servo wiring. It would be relatively heavy
and stiff and quite difficult to work with. UTP / Cat5 would probably be OK
except that its a bit thin.

RJ11/RJ45 connectors are not designed for repeated connecting and
disconnecting. They're typically a "insulation displacement" type of
connector where the cable strands are forced into the plug or socket using a
form of crimping tool such that each connector pin cuts through a
conductor's insulation to make the contact, an arrangement I'd not like in a
plane.

If you want a cheap multipin connector that is reliable then try using those
flat "USB" connectors that are used these days to connect peripherals to
computers. USB is four wire with two conductors fairly large gauge to carry
power and two thinner to carry the signal. I'd cannibalize a USB cable for
the wing harness and use a twin USB socket salvaged from a redundant
motherboard for the fuse. These connectors are designed to be repeatedly
plugged and unplugged, they're quite small and light.

Martin Usher

RCSE-List facilities provided by Model Airplane News.  Send "subscribe" and 
"unsubscribe" requests to [EMAIL PROTECTED]  Please note that subscribe and 
unsubscribe messages must be sent in text only format with MIME turned off.

Reply via email to