Nicely done Mike. Thanks!
[EMAIL PROTECTED] wrote:
"Bill Swingle" <[EMAIL PROTECTED]> wrote:
It looks like the Hobbico antenna utilizes a stereo plug (2 conductors +
grd) While Mike's uses a mono plug (1 conductor + grd).
Inside the frequency checker there are two boards. One is a large LED dot
matrix display that includes the antenna jack on one side. The other is the
smaller rf board, which leaves enough room for the batteries to fit inside
the case. Here's a picture: http://www.vvsss.com/freq_checker/both_boards.jpg
The rf board has a single seven-inch antenna wire coming out of it that wraps
around the inside of the case and ends at the antenna jack on the dot matrix
board. With no external antenna plugged in, this seven-inch wire alone acts
as the antenna.
Now look at this picture: http://www.vvsss.com/freq_checker/matrix_back.jpg
This is the back of the dot matrix board, which has a PIC microcontroller
just above the antenna jack. You can also see the battery connectors.
Notice that the end of the antenna wire connects only to the ground or shield
terminal of the antenna connector, which appears to be a stereo jack. I was
unable to find any connection of the tip and center terminals of the jack to
any on the circuitry on the dot matrix board, nor did I expect to find any.
Those terminals are merely soldered to an isolated portion of the board to
help secure the jack in place.
The bottom line is that it doesn't make a bit of difference whether you use a
mono or stereo plug for your antenna because only the shield (ground)
terminal connects to anything inside the frequency checker. Whatever you plug
into the ground connection of that jack will act as an extension of the
existing seven-inch antenna wire.
Here's a cute animated GIF I made to show how fast the frequency checker
scans: http://www.vvsss.com/freq_checker/freq_checker.gif
Mike
RCSE-List facilities provided by Model Airplane News. Send "subscribe" and
"unsubscribe" requests to [EMAIL PROTECTED] Please note that subscribe and unsubscribe
messages must be sent in text only format with MIME turned off. Email sent from web based email
such as Hotmail and AOL are generally NOT in text format
